April 8, 2016

Nighttime Milling and Resurfacing on Route 20 Begins Sunday

This article was archived from the previous WordPress site. Formatting and media should be close, but may not match the original post perfectly.

The Connecticut Department of Transportation has announced that a nighttime milling and resurfacing project will be performed on Rt. 20 westbound from I-91 to Bradley International Airport. The 6.94 mile segment runs through East Granby, Windsor, and Windsor Locks. The project is scheduled to occur from Sunday, April 10 to Thursday, May 5.

The milling segment of this project will run from April 10 to April 21, while the resurfacing is anticipated to begin April 17 and run through May 5.

Latest Posts

EPA Responds to Reps. Zawistowski and Carney re: Up-river Discharges in CT River

State Representatives Tami Zawistowski (R-61) and Devin Carney (R-23) announced today that federal Environmental Protection Agency officials have responded to their request for assistance regarding continued up-river sewage and stormwater overflow discharges in the Connecticut River following major rain events. “While the EPA acknowledged the persistent problem of combined sewer overflows from up-river municipalities and […]

September 18, 2025

Rep. Zawistowski Achieves 100% Voting Record

State Representative Tami Zawistowski (R-61) achieved a one-hundred-percent voting record during the 2025 regular Legislative Session according to statistics compiled by the House Clerk’s Office! This year, Rep. Zawistowski cast her vote on 381 separate pieces of legislation that made it to the floor of the House of Representatives during the regular session. Only about […]

September 16, 2025